Heat Shrink Tubing Processing Machine - KINGSING

  1. Home page
  2. Services
  3. Company News

How to use the automatic wire stripping machine

2022-10-13 14:24:39 美工

KINGSUN


  • The wire is inserted from the wire inlet, passes through the wire inlet wheel, and is placed on the knife edge through the conduit;

  • Adjust the gap of the wire feeder, and adjust the gap between the two wheels to be smaller than the outer diameter of the wire to be stripped through the "wire feeder clearance adjustment wheel", and ensure normal wire stripping;

  • Adjustment of the gap between the outlet pulleys: adjust the gap between the two wheels through the "gap adjustment wheel of the outlet pulley" until the gap between the two wheels is smaller than the outer diameter of the wire to be stripped, and adjust the disconnection indicator when it is in the critical state of on and off, and then rotate in the larger direction for half a turn . If there is still a knot of the wire and the machine stops, adjust the gap a little bit smaller.